[. . . ] ρ¬ The cooling circuit in this appliance contains the refrigerant isobutane (R600a), a natural gas with a high level of environmental compatibility, which is nevertheless flammable. Ensure, therefore, that none of the components of the refrigerant circuit become damaged during transportation and installation of the appliance. If damage to the cooling circuit does occur, do not switch on or connect the appliance to the mains power. In the case that there is an open fire or any other sources of ignition in the vicinity of the refrigerant gas, make sure it is removed immediately from this area and that the room is then thoroughly ventilated. [. . . ] ρ¬ Do not place any objects on top of the unit, and do not otherwise cover it. ρ¬ If the floor is uneven, the adjustable foot can be used to compensate and ensure optimum stability. Ventilation Ensure that there is enough space around the unit so that the air circulation round and behind it is not obstructed. Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Use a suitable screw-driver to remove the two screws (2) holding the upper hinge (3) to the housing. Carefully lift up the door and place it on a soft surface to protect it from scratches. Pull out the two bolts (7) which hold the lower right hinge plate (4) and the adjustable foot (6) in position. Remove the adjustable foot (8) on the left and insert it into the corresponding thread on the right. Ensure that the hinge pin is inserted into the guide bushing (hole) on the lower part. Ensure that the hinge pin is inserted into the guide bushing (hole) on the upper part. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. 1 3 5 The cooling function is switched off; however, the appliance is still connected to the mains. To switch off the unit completely, the plug must be removed from the wall socket. After a certain time, the actual temperature should then be checked with a thermometer, and adjustments made if necessary. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. Storing food – The temperatures inside the refrigerator cabinet and cold storage compartment depend mainly on the ambient temperature, the temperature control setting and the amount of food stored. Cold storage compartment: – The cold storage compartment is specifically designed for short-term storage of fresh meat, fish and poultry. 13 Main cabinet – Different areas of the refrigerator cabinet are affected differently by the cooling effect. The warmest area is around the door in the higher part of the cabinet, the coldest around the rear wall and in the lower part of the cabinet. [. . . ] €“ – – Transporting the appliance The unit must only be transported in its vertical position. During transport, ensure that the unit is properly secured and protected against shock, vibration and shifting. To ensure optimum performance, wait a minimum of 2 hours after transporting the unit before connecting it to the mains. disposal This appliance has been manufactured from recyclable materials. [. . . ]